Honeywell Alarm
I have a Honeywell alarm 48 D view, the panel makes me FC and I do not work, and remove the central connection, I would like to know that I have to reactivate it and call me mobile. Before answering your question (before I take a look at the manual of the plant because you have not worked with her and not want to answer incorrectly), would want you to tell me what you mean when you say that and remove the connection to plant,. You mean that you have discharged from the service of some central station?. If so and the plant has not been rescheduled, which leaves you an indication of communication failure that occurs when you try to contact the Central with the recipient to convey the events and receive no response nor Logioco code of correct reception by part of it. Well, then I fear you must first turn to the person or company that you installed it to modify the program and disable the central communicator, and not just unsubscribe at the station. The plant does not know of paperwork and in accordance with the programming that was performed, each time an event occurs that would convey to the recipient (usually connections, disconnections, breaks alarm, network failures, low batteries, etc. . . ), try to do what was told to do, is communicate with the central station by calling and receiving no response it will give you the communications failure. If anything, you know what the engineer code to give you access to PBX programming I can tell you what would be the parameter to be changed, but I fear that this information, which is generally unknown to almost all customers will not know and each program installation company engineer their own code and it never makes it easier for customers to avoid causing problems and getting where it should not fret on the PBX programming. It would be very difficult to get the code had been left "factory", we would rather say impossible. On the other hand, on to the other matters raised, you will not be able to make the central call you directly to your mobile, rather, knowing the engineer code, if you could reprogram the central market instead of the number of monitoring station phone call your mobile, but only going to hear a series of pitiditos like those issued by fax, (for comparártelo to something that might sound familiar), and central to not receive the confirmation code continue showing adequate notice of failure to communicate. The solution would be to add a voice dialer activated by a relay driven by the plant, which would you call, you send a voice message to phones that will allow you to program and even to hear the sounds inside your home or premises if they covet. But back to the initial theme, call your installer, who will be known to the engineer code, and request that the phone dialer disable your Vista. Tell if you have to apply the services of another company to return the plant to factory settings and schedule and pitch again and you install the voice dialer. On the other hand do not know if you know that if you're not connected to the receiver is not connected to the system allowed to have any outdoor siren and if you had one it would be best disconnect the system (first remove the internal battery if it has since otherwise, or simply unplugging the power cables would remain sound until your battery run out and that is something really annoying especially for the neighbors). . . .
